Page 6
PARTS INCLUDED FOR INSTALLATION (parts are not to scale):
3ea Wire Connectors (#15) 1ea Ground Screw (#16) 1ea Hex Nut (#17)
1ea Mounting Strap (#18) 1ea Nipple (#19) 2ea Outlet Box Screws (#20)
INSTALLATION INSTRUCTIONS:
1. Screw the Nipple (#19) a half-inch into the Mounting Strap (#18). Tighten the Hex Nut (#17)
against the Mounting Strap (#18) to secure the Nipple (#19). Attach the Mounting Strap (#18)
to the Outlet Box (#14) using the two Outlet Box Screws (#20). [Make sure the longer end
of the Nipple (#19) is facing outside when the Mounting Strap (#18) is attached to the Outlet
Box (#14).]
2. Adjust the Chain (#3) to required height by lifting the fixture and attaching the Quick Link
(#21) to the Loop (#5) and to a link of Chain (#3) closer to the ceiling. The fixture can be
raised and lowered in this manner until the desired height is achieved. Next, use pliers and a
screwdriver to twist open (cover the chain with cloth to prevent damage to the link finish)
the first unused link of Chain (#3). Remove and save the excess chain. Pull the excess
fixture wires through the Nipple (#19) into the Outlet Box (#14). Wires may be left at full
length or shortened as determined by space in the Outlet Box (#14) to make the wire
connections.
3. Wrap the ground wire from the fixture around the Ground Screw (#16) on the Mounting
Strap (#18), and then connect the ground wire from the fixture to the ground wire from the
Outlet Box (#14). Connect the wire without writing on it (with raised ribs) from the fixture
to the white wire (neutral wire) from the Outlet Box (#14). Connect the wire with writing on
it from the fixture to the black wire (live wire) from the Outlet Box (#14). Cover the three
connections using the three Wire Connectors (#15). Wrap the three wire connections with
electrical tape for a more secure connection. Position the wires back inside the Outlet Box
(#14). Note: If you have electrical questions, consult your local electrical code for approved
grounding methods.
4. Place the Canopy (#1) over the Nipple (#19) all the way to the ceiling. Tighten the Ring (#4)
onto the Screw Collar Loop (#2) until the Canopy (#1) is held firmly against the ceiling.
5. Installation is complete. Turn on the power at the circuit breaker or fuse box. Turn the light
switch on to activate the fixture.
(9 pages)
(26 pages)
(24 pages)
Manymanuals.com
Manymanuals.de
Manymanuals.fr
Manymanuals.it
Manymanuals.pl
Manymanuals.cz
Manymanuals.es
Manymanuals-pt.com
Commentaires sur ces manuels