Hampton Bay 51353 Guide d'installation télécharger pdf (Page 7)

HAMPTONBAY.COM

Please contact 1-877-527-0313 for further assistance.

Assembly - Standard Ceiling Mount

Routing the wires

Assembling the fan

Preparing for mounting

□ Loosen, but do not remove, the setscrew (HH) on the collar on top

of the fan-motor assembly (E).

□ Align the holes at the bottom of the ball/downrod assembly (B)

with the holes in the collar on top of the fan-motor assembly (E).

□ Carefully insert the hanger pin (CC) through the holes in the collar

and ball/downrod assembly (B). Be careful not to jam the hanger

pin (CC) against the wiring inside the ball/downrod assembly (B).

□ Insert the locking pin (DD) through the hole near the end of the

hanger pin (CC) until it snaps into its locked position.

□ Re-tighten the setscrew (HH) on the collar on top of the fan-

motor assembly (E).

□ Remove the canopy ring (O) from the canopy (C) by turning

the ring to the right until it unlocks.

□ Remove the mounting bracket (A) from the canopy (C) by

loosening the four screws on the top of the canopy (C).

□ Remove the two non-slotted screws, and loosen the slotted

screws. This will enable you to remove the mounting bracket

(A).

□ Route the wires exiting the top of the fan motor (E) into

the decorative motor collar cover (D) and through the

canopy ring (O).

□ Make sure the slot openings are on top and route the

wires through the canopy (C) and then through the ball/

downrod assembly (B).

WARNING: Failure to properly install the locking pin could

result in the fan becoming loose and possibly falling.

1 2 3 4 5 6 7 8 9 10 11 12 ... 29 30

Pas de commentaire

Hampton Bay 51353 Guide d'installation Page 7