Hampton Bay 56152 Guide d'installation télécharger pdf (Page 8)

6.

EACH WIRE NUT (WIRE CONNECTOR) SUP-

PLIED WITH THIS FAN IS DESIGNED TO ACCEPT

UP TO ONE 12 GAUGE HOUSE WIRE AND TWO

WIRES FROM THIS FAN. IF YOU HAVE LARGER

THAN 12 GAUGE HOUSE WIRING OR MORE

THAN ONE HOUSE WIRE TO CONNECT TO THE

FAN WIRING, CONSULT AND ELECTRICIAN FOR

THE PROPER SIZE WIRE NUTS TO USE.

Figure 8

Finishing the Fan

Installation

STANDARD CEILING MOUNTING

WHEN USING THE STANDARD BALL/DOWN-

ROD MOUNTING, THE TAB IN THE RING AT THE

BOTTOM OF THE MOUNTING BRACKET MUST

REST IN THE GROOVE OF THE HANGER BALL.

FAILURE TO PROPERLY SEAT THE TAB IN THE

GROOVE COULD CAUSE DAMAGE TO WIRING.

1. Align the locking slots of the ceiling canopy

with the two screws in the mounting bracket.

Push up to engage the slots and turn clock-

wise to lock in place. Immediately tighten

the two mounting screws rmly.

2. Install the remaining two mounting

screws into the holes in the canopy and

tighten rmly.

3. Install the decorative canopy ring by align-

ing the ring’s slots with the screws in the

canopy. Rotate the ring counter-clockwise

to lock in place.

4. You may now proceed to attaching the

fan blades.

Setting the Code

This unit has 16 different code combinations.

To set the code, perform the following steps:

A. Setting the code on the transmitter:

a. Remove the battery cover. Press rmly

below arrow and slide battery cover off.

b. Slide code switches to your choice of up

or down position. (Factory setting is all up).

B. Setting the code on the receiver.

a. Slide code switches to the same position

as set on your transmitter.

b. Replace battery cover on transmitter.

CAUTION:

Ceiling angle shall not exceed 30 degrees.

Controller Model: UC7067RYK

1 2 3 4 5 6 7 8 9 10 11 12 13 ... 26 27

Commentaires sur ces manuels

Pas de commentaire