Hampton Bay 56152 Guide d'installation télécharger pdf (Page 7)

5.

Figure 7

1. Pass the 120-volt supply wires through the

center hole in the ceiling mounting plate as

shown in Figure 7.

2. Install the ceiling mounting plate on the out-

let box by sliding the mounting plate over

the two screws provided with the outlet box

(Figure 7). If necessary, use leveling wash-

ers (not included) between the mounting

bracket and the outlet box. Note that the at

side of the mounting plate is toward the out-

let box (Figure 7).

3. Securely tighten the two mounting screws.

4. Carefully lift the fan assembly up to the ceil-

ing mounting plate. Make sure the tab on

the mounting plate is properly seated in the

groove in the hanger ball.

Making the Electrical

Connections

REMEMBER to disconnect the power. If

you feel you do not have enough electrical

wiring knowledge or experience, have your fan

installed by a licensed electrician.

Follow the steps below to connect the fan to your

household wiring (or follow the instructions

included along with the remote control).

Use the wire connecting nuts supplied with

your fan. Secure the connectors with electrical

WHEN MOUNTING THE FAN ON A SLOPED

CEILING, THE STANDARD BALL/DOWNROD

MOUNTING METHOD MUST BE USED. MAKE

SURE THE MOUNTING BRACKET SLOTS ARE

ON THE LOWER SIDE BY SLIDING THE MOUNT-

ING PLATE FROM THE TOP DOWN.

Installing Fan to

the Outlet Box

tape. Make sure there are no loose strands or

connections (Figure 8).

1. Connect both green wires from the down-

rod and mounting plate to the bare copper

(Ground) from the outlet box.

2. Connect the black wire (AC IN L) from

the receiver unit to the black wire from the

outlet box.

3. Connect the white wire (AC IN N) from

the receiver unit to the white wire from the

outlet box.

4. Connect the white wire (To Motor N) from

the receiver unit to the white wire from the

fan assembly.

5. Connect the black wire (To Motor L) from

the receiver unit to the black wire from the

fan assembly.

6. Connect the blue wire (For Light) from the

receiver unit to the blue wire from the fan.

After the wires are connected, carefully tuck

them into the outlet box. Insert the receiver unit

into the mounting plate; make sure the black an-

tenna wire sits on top of the receiver unit.

THE FREQUENCIES ON YOUR RECEIVER AND

TRANSMITTER HAVE BEEN PRESET AT THE

FACTORY. BEFORE INSTALLING THE RECEIV-

ER, MAKE SURE THE DIP SWITCHES ON THE

RECEIVER AND TRANSMITTER ARE SET TO

THE SAME FREQUENCY. THE DIP SWITCHES

ON THE TRANSMITTER ARE LOCATED INSIDE

THE BATTERY COMPARTMENT.

1 2 3 4 5 6 7 8 9 10 11 12 ... 26 27

Commentaires sur ces manuels

Pas de commentaire