Hampton Bay EC410ABZ Manuel d'utilisation et d'entretien Page 2

  • Télécharger
  • Ajouter à mon manuel
  • Imprimer
  • Page
    / 8
  • Table des matières
  • MARQUE LIVRES
  • Noté. / 5. Basé sur avis des utilisateurs
Vue de la page 1
2
Thank you for purchasing this Hampton Bay interior track pendant. This product has been manufactured with the highest standards
of safety and quality.
FEATURES:
1. Track pendant can be installed anywhere along the track section (sold separately).
2. Track Pendant is adjustable in length and comes complete with a Do-It-Yourself Pendant Adapter and a direct wire canopy.
3. The wire can be cut to desired lengths for different applications and ceiling heights.
QUESTIONS, PROBLEMS, MISSING PARTS:
Before returning to your local Home Depot, please call our Customer Service Team at 1-877-527-0313 or visit
www.homedepot.com. Please reference SKU828650, UPC008938241090.
GENERAL
All electrical connections must be in accordance with local codes, ordinances or national electrical codes. If you are unfamiliar
with methods of installing electrical wiring, secure the services of a qualified electrician. Before starting installation, disconnect
the power by turning off the circuit breaker or removing the fuse at fuse box. Turning the power off using the light switch is not
sufficient to prevent electrical shock.
Note: The important safeguards and instructions appearing in this manual are not meant to cover all possible conditions and
situations that may occur. It must be understood that common sense, caution and care are factors that cannot be built into any
product. These factors must be supplied by the person(s) caring for, installing and operating the fixture. If at any time you are
uncomfortable or are unsure of what to do, please contact a qualified licensed electrician for further assistance.
IMPORTANT SAFETY INSTRUCTIONS
1. Read all instructions.
2. Do not install this lighting system in a damp or wet location.
3. Before energizing make sure that the lighting system is clear of all material which could cause a direct short and check all
electrical connections to make sure they are tight.
4. Do not install any part of this system (TRACK) less than 7 feet (2.2m) above floor.
5. To reduce the risk of fire and burns, do not install this lighting system where non insulated open bus-bar conductors can be
shorted or contact any conductive metals.
6. To reduce the risk of fire and overheating, make sure all connections are tight.
7. Turn off electrical power before modifying the light system in anyway.
8. For installation with HAMPTON BAY EC series track only.
9. CAUTION – To reduce the risk of a burn during re-lamping, remove from the track before re-lamping
.
10. Do not install any luminaire assembly closer than 6 inches from any curtain, or similar combustible material.
11. DANGER – RISK OF SHOCK – DISCONNECT POWER BEFORE INSTALLATION.
SAVE THESE INSTRUCTIONS
TOOLS REQUIRED FOR ASSEMBLY & INSTALLATION (not included):
Ladder Safety goggles Wire stripper Gloves Flathead screwdriver Phillips screwdriver
Electrical tape Light bulb
PARTS INCLUDED FOR ASSEMBLY (parts are not to scale):
x1 canopy x1 Pendant
Fixture x1 Hardware Packet
ASSEMBLY INSTRUCTIONS (AS SHOWN IN DIAGRAM):
This pendant is already assembled and ready for installation to the track section. Proceed to Installing Fixture to Track. Section if
you do not need to adjust the length of the wire. Please follow these instructions if you do need to adjust the length of the wire.
1. On the Adapter, remove the set screw on the side of the top end of the adapter as shown in Figure 1. Unscrew the
bushing and slide it down the wire a few inches. Keep these parts handy for the final installation.
Box
Vue de la page 1
1 2 3 4 5 6 7 8

Commentaires sur ces manuels

Pas de commentaire