Hampton Bay AM212-WH Manuel d'instructions télécharger pdf (Page 12)

Making the electrical

connections

If you feel you do not have enough electrical wiring

knowledge or experience, have your fan installed by a

licensed electrician.

Follow the steps below to connect the fan to your

household wiring. Use the plastic wire nuts (AA) with your

fan. Secure the plastic wire nuts (AA) with electrical tape.

Make sure there are no loose strands or connections.

□ Connect the ground conductor (TT) of the 120V supply

(this may be a bare wire or a wire with green colored

insulation) to the green ground lead(s) (NN) of the fan.

When using standard ceiling mounting, there are two

green grounding leads: one from the mounting

bracket (A) and one from the hanger ball/downrod

assembly (D). When using “close-to-ceiling”

mounting, there is only one green ground lead (NN)

from the mounting bracket (A) since the hanger

ball/downrod assembly (D) is not used.

□ Connect the fan motor white wire (OO) to the supply

white (neutral) wire (SS) using a plastic wire nut (AA).

□ Connect the fan motor black wire (PP) and the blue

wire (QQ) to the supply black (hot) wire (RR) using a

plastic wire nut (AA).

□ Turn the wire nut connections upward, spreading

them apart so the green (ground) (NN) will be on one

side of the outlet box (LL) and the white (OO), black

(PP) and blue wire (QQ) will be on the other side.

Carefully tuck the connections up into the outlet box

(LL).

WARNING: Check to see that all connections are tight,

including ground, and that no bare wire is visible at the wire

nuts (except for the ground wire).

WARNING: To reduce the risk of ﬁre or electric shock, do

not use this fan with any solid-state speed control device.

WARNING: To avoid possible electrical shock, be sure

electricity is turned off at the main fuse box before wiring.

Assembly — Hanging the Fan (continued)

1 2 ... 7 8 9 10 11 12 13 14 15 16 17 ... 20 21

Pas de commentaire

Hampton Bay AM212-WH Manuel d'instructions Page 12