Hampton Bay AL634-NI Manuel d'utilisation et d'entretien télécharger pdf (Page 12)

Installing the Light Kit

Remove the 1 of 3 light kit mounting screws

from the posts of the light kit mounting plate

and keep it for future use. Loosen the other 2

screws. (Do not remove)

While holding the light plate under your fan

motor assembly, snap together the 9 pin

connection plugs. one from the fan motor

assembly, and the other from the light plate.

Place the key holes on the light plate over the 2

light kit mounting screws previously loosened

from the mounting ring, turn the light plate

until he light plate locks in place at the narrow

section of the key holes. Secure by tightening

the 2 light kit mounting screws previously

loosened and the one previously removed.

(Fig. 15)

Install two 13 watt compact fluorescent bulbs

(included) to the light sockets.

Raise the glass shade/decorative frame

assembly up against bottom of light kit, align

1.

2.

3.

4.

5.

CAUTION

BEFORE STARTING INSTALLATION, DISCON-

NECT THE POWER BY TURNING OFF THE

CIRCUIT BREAKER OR REMOVING THE FUSE

AT FUSE BOX. TURNING POWER OFF USING

THE FAN SWITCH IS NOT SUFFICIENT TO

PREVENT ELECTRIC SHOCK.

NOTE

LIGHT BULBS HAVE NO WARRANTY; CAN BE

PURCHASED AT ANY HOME DEPOT STORE.

Figure 15

Mounting

Plate

Connector Plugs

Light

Plate

Screws

Screws

Glass Shade/

Decorative Frame

Assembly

the holes in the rim of the decorative frame

with the light kit and secure using the three

decorative screws provided with the light kit

hardware. DO NOT OVER TIGHTEN.EN.

(Fig. 15)

9

Bulb

1 2 ... 7 8 9 10 11 12 13 14 15 16

Commentaires sur ces manuels

Pas de commentaire