Hampton Bay AC386-WB Manuel d'utilisation et d'entretien

Savona Tiffany52 in Ceiling FanOwner’s Manual Savona TiffanyVentilador de Techo de 1,32 mManual del Propietario 285 987

8Attaching the Fan BladesInsert the blade through the blade slot in the decorative housing. Align the holes in blade and blade arm, place the blade ar

9Installing the Light KitYour fan and light kit though pre-wired have been disassembled at the factory to ease in shipping. Please follow these steps

1010Installing the Battery:"HI, MED, LO" buttons:These three buttons are used to set the fan speed as follows:LO=Low speed, MED= Medium spee

11Speed settings for warm or cool weather depend on factors such as the room size, ceiling height, number of fans, etc.Warm weather - (Counter-Clockwi

12WARNINGMAKE SURE THE POWER IS OFF AT THE ELECTRICAL PANEL BOX BEFORE YOU ATTEMPY ANY REPAIRS. REFER TO THE SECTION, “MAKING ELECTRICAL CONNECTIONS”.

13SpecificationsFAN SIZE SPEED VOLTS AMPS WATTS RPM CFM N.W. G.W. C.F.52” 12011.29 kgs(28.84 lbs)12.59 kgs(27.70 lbs)2.6’LOWMED.HIGH0.320.520.59124170

14The Hampton Bay warrants the fan motor to be free from defects in workmanship and material present at time of shipment from the factory for a period

52” Savona TiffanyCeiling Fan by Hampton BayDate PurchasedStore PurchasedUL Model No.Serial No.Vendor No.UPCThank you for purchasing our ceiling fan.

Safety Rules - Read and Save These Instructions1To reduce the risk of electric shock, insure electricity has been turned off at the circuit breaker or

2Unpacking Your FanUnpack your fan and check the contents. You should have the following items:ABDCSet of blades (5)Canopy assemblyBall/downrod assemb

3Installing Your FanFigures 1~3 are examples of different ways to mount the outlet box.If there isn't an existing UL listed mounting box, then re

4REMEMBER to turn off the power. Follow the steps below to hang your fan properly.Hanging the FanWARNINGFAILURE TO PROPERLY INSTALL COTTER PIN AS NOTE

5WARNINGTHE TAB IN THE RING MUST REST IN THE GROOVE OF THE HANGER BALL AS FIGURE 8. FAILURE TO PROPERLY SEAT THE TAB IN THE GROOVE COULD CAUSE DAMAGE

6Making the Electrical ConnectionsWARNINGTO AVOID POSSIBLE ELECTRICAL SHOCK, BE SURE ELECTRICITY IS TURNED OFF AT THE MAIN FUSE BOX BEFORE WIRING.If y

7WARNINGMAKE SURE THE TAB ON THE HANGING BRACKET PROPERLY SITS IN THE GROOVE IN THE HANGER BALL BEFORE ATTACHING THE CANOPY TO THE BRACKET BY TURNING